Motul 5W30 Fully Synthetic Diesel Engine Oil Specific VW 504 00 507 00 106375
TYPE OF USE
Specifically designed for VAG Group recent cars (VOLKSWAGEN, AUDI, SKODA and SEAT) fitted with Euro 4, 5 and 6 engines that require lubricants with low Sulfated Ash, low Phosphorus and low Sulfur contents (Low SAPS).
MOTUL SPECIFIC 504 00 507 00 5W-30 is fully backward compatible over previous VW oil standards such as VW 501 01, 502 00, 503 00 and 503 01 for Gasoline engines, and VW 505 00, 505 01, 506 00 and 506 01 for Diesel engines.
VOLKSWAGEN R5 and V10 TDI engines from MY2003 to MY2007 must only use an approved VW 506 01 lubricant in viscosity grade 0W-30 such as MOTUL SPECIFIC 506 01 506 00 503 00 0W-30 or MOTUL SPECIFIC 504 00 507 00 0W-30.
Drain intervals remain fixed at 15 000 km in Europe for any car calling exclusively for VW 501 01, 502 00, 505 00 or 505 01 oils even if the vehicle is using MOTUL SPECIFIC 504 00 507 00 5W-30 or MOTUL SPECIFIC 504 00 507 00 0W-30.
If in doubt, before use always refer to the owner’s manual.
PERFORMANCES
STANDARDS ACEA C3
APPROVALS VW 504 00 507 00
Engines compliant with Euro 4, 5 and 6 emission regulation are fitted with sensitive exhaust gas after treatment systems.
Indeed, Sulfur and Phosphorus inhibit catalytic converters operation leading to inefficient exhaust gas treatment; and Sulfated Ash clogs DPFs leading to shorten regenerating cycle, quick oil aging, higher fuel consumption, and engine power loss.
VOLKSWAGEN has developed VW 504 00 and 507 00 standards for lubricants with low Sulfur, Phosphorus and Sulfated Ashes content, compatible with their after treatment systems such as catalytic converters, SCR (Selective Catalytic Reduction) and DPF, in order to guarantee a perfect durability of VAG group engines (VOLKSWAGEN, AUDI, SKODA and SEAT).
These types of “long life” oils allow extended drain intervals managed by vehicles on-board computer.
RECOMMENDATIONS
Drain interval: refer to manufacturers’ recommendations and tune to your own use.
Do not mix with lubricants non VW 504 00 507 00 compliant.
Before use always refer to the owner manual or handbook of the vehicle.
PROPERTIES
Viscosity grade SAE J 300 5W-30
Density at 20°C (68°F) ASTM D1298 0.848
Viscosity at 40°C (104°F) ASTM D445 68.3 mm²/s
Viscosity at 100°C (212°F) ASTM D445 11.8 mm²/s
HTHS viscosity at 150°C (302°F) ASTM D4741 3.5 mPa.s
Viscosity Index ASTM D2270 171.0
Pour point ASTM D97 -39.0 °C / -38.0 °F
Sulfated Ash ASTM D874 0.68 % weight
TBN ASTM D2896 6.8 mg KOH/g
Flash point ASTM D92 226.0 °C / 439.0 °F
Share some information about your product
Share some information about your product
Share some information about your product
Motul 5W30 Fully Synthetic Diesel Engine Oil Specific VW 504 00 507 00 106375
TYPE OF USE
Specifically designed for VAG Group recent cars (VOLKSWAGEN, AUDI, SKODA and SEAT) fitted with Euro 4, 5 and 6 engines that require lubricants with low Sulfated Ash, low Phosphorus and low Sulfur contents (Low SAPS).
MOTUL SPECIFIC 504 00 507 00 5W-30 is fully backward compatible over previous VW oil standards such as VW 501 01, 502 00, 503 00 and 503 01 for Gasoline engines, and VW 505 00, 505 01, 506 00 and 506 01 for Diesel engines.
VOLKSWAGEN R5 and V10 TDI engines from MY2003 to MY2007 must only use an approved VW 506 01 lubricant in viscosity grade 0W-30 such as MOTUL SPECIFIC 506 01 506 00 503 00 0W-30 or MOTUL SPECIFIC 504 00 507 00 0W-30.
Drain intervals remain fixed at 15 000 km in Europe for any car calling exclusively for VW 501 01, 502 00, 505 00 or 505 01 oils even if the vehicle is using MOTUL SPECIFIC 504 00 507 00 5W-30 or MOTUL SPECIFIC 504 00 507 00 0W-30.
If in doubt, before use always refer to the owner’s manual.
PERFORMANCES
STANDARDS ACEA C3
APPROVALS VW 504 00 507 00
Engines compliant with Euro 4, 5 and 6 emission regulation are fitted with sensitive exhaust gas after treatment systems.
Indeed, Sulfur and Phosphorus inhibit catalytic converters operation leading to inefficient exhaust gas treatment; and Sulfated Ash clogs DPFs leading to shorten regenerating cycle, quick oil aging, higher fuel consumption, and engine power loss.
VOLKSWAGEN has developed VW 504 00 and 507 00 standards for lubricants with low Sulfur, Phosphorus and Sulfated Ashes content, compatible with their after treatment systems such as catalytic converters, SCR (Selective Catalytic Reduction) and DPF, in order to guarantee a perfect durability of VAG group engines (VOLKSWAGEN, AUDI, SKODA and SEAT).
These types of “long life” oils allow extended drain intervals managed by vehicles on-board computer.
RECOMMENDATIONS
Drain interval: refer to manufacturers’ recommendations and tune to your own use.
Do not mix with lubricants non VW 504 00 507 00 compliant.
Before use always refer to the owner manual or handbook of the vehicle.
PROPERTIES
Viscosity grade SAE J 300 5W-30
Density at 20°C (68°F) ASTM D1298 0.848
Viscosity at 40°C (104°F) ASTM D445 68.3 mm²/s
Viscosity at 100°C (212°F) ASTM D445 11.8 mm²/s
HTHS viscosity at 150°C (302°F) ASTM D4741 3.5 mPa.s
Viscosity Index ASTM D2270 171.0
Pour point ASTM D97 -39.0 °C / -38.0 °F
Sulfated Ash ASTM D874 0.68 % weight
TBN ASTM D2896 6.8 mg KOH/g
Flash point ASTM D92 226.0 °C / 439.0 °F
Share some information about your product
Share some information about your product
Share some information about your product